Ness D16 - MONITORING; CENTRAL STATION MONITORING

NESS D16 CONTROL PANEL - USER MANUAL
17
PROGRAMMING
1. Press
[MASTER CODE]
(Enters Program Mode. The PROGRAM light will turn on).
2. Press (The existing Telephone No. will be displayed by the keypad lights)
3. Press (The new Telephone No. will be displayed)
(Enter the new Telephone Number).
4. Press then
(To exit Program Mode. The PROGRAM light will turn off).
PROGRAMMING FOLLOW ME TELEPHONE NUMBER
EXAMPLE 5:
To program the Follow Me Telephone Number
00
Enter the new Telephone Number (Up to 15 digits long)
EXAMPLE 6:
To delete the Follow Me Telephone Number
1. Press
[MASTER CODE]
(Enters Program Mode. The PROGRAM light will turn on).
2. Press (The existing time will be displayed by the keypad lights)
(Enter the Option Number of the Timer to be programmed. See Options Table).
3. Press
(Enter the new time, from 1-99 seconds).
4. Press then
(To exit Program Mode. The PROGRAM light will turn off).
PROGRAMMING ENTRY/EXIT TIMERS
EXAMPLE 4: To program EXIT DELAY.EXAMPLE 3: To program ENTRY DELAY 1.
Technical Manuals Online! - http://www.tech-man.com