NESS D16 CONTROL PANEL - USER MANUAL
20
OPERATING THE D16 BY TELEPHONE
The D16 will allow a user to call in to the
panel, using a standard DTMF telephone,
and remotely Arm or Disarm all areas and
also turn on or off Aux 1 and Aux 2.
To ensure security of operation a user can
only carry out remote operations after
entering a valid user code.
REMOTE CONTROL FUNCTIONS NEED:
• A telephone with DTMF tones.
• A Valid User code programmed in the
D16.
• The Telephone number that the D16 is
connected to.
SEQUENCE OF OPERATION.
1. Phone the D16 telephone number and
listen for the required number of rings
(ring ring...ring ring) and then hang up.
2. Wait 10 seconds and then call the
number again within 50 seconds.
3. The D16 will answer the second call
immediately, sound a beep for 2 seconds
then, after a pause, it will sound a lower
frequency tone. The D16 is now ready to
receive telephone commands.
4. Press the
button on the telephone.
This tells the D16 that telephone
commands will follow. The D16 will
respond with either 3 beeps if all OK
(One long beep means try again).
5. Now enter a valid User Code (that is
normally used for Arming or Disarming
the D16) followed by the
button.
The D16 will respond with 3 beeps if it
REMOTE OPERATION
recognises the code or 1 long beep to
signal the code was invalid and to try
again.
6. Enter the required command.
See: Summary Of Telephone Commands.
7. Press
to finish. This tells the D16
to hang up. Also hang up your
telephone.
AUDIBLE FEEDBACK
3 BEEPS:
• The User Code is valid
• Successful Arming or Disarming
• An Auxiliary output has been turned ON.
1 LONG BEEP:
• D16 is already Armed
• Invalid code. Try again.
1 SHORT BEEP:
• An Auxiliary output has been turned OFF.
NOTES
• If the D16 does not receive commands for
periods longer than 10 seconds it will
assume that the call is finished and it will
hang up.
• If an alarm occurs which requires the D16
to dial out while attempting remote
control, the D16 will treat the alarm as a
priority, give a constant tone as a warning
and then hang up.
• When all remote control commands are
finished press
to force the D16 to
hang up.
Technical Manuals Online! - http://www.tech-man.com
To Next Page
Loading...
Need help?
General
