NESS D16 CONTROL PANEL - USER MANUAL
9
ARMING YOUR ALARM SYSTEM
The control panel must be Armed prior to
vacating the premises in order to detect
intruders. Ensure that the panel is not in
Program, Memory or Exclude modes.
Note: If the panel is already in alarm, you must first
silence the alarm before you can Arm.
If something is wrong when Arming the
control panel, the normal 3 beeps will be
replaced by other warnings.
10
10 beeps means Mains Power is
turned off or the Backup Battery is low.
One long beep indicates an invalid
entry or an alarm is outstanding and needs
to be reset by entering your User Code first.
1. The NOT READY light must be off
2. Press
[User Code]
...or
(If Arming Shortcut has been enabled by your installer)
...or by RADIO KEY, press the ON button
3. The ARMED light will turn on
• Leave the premises within the Exit Delay Time
• At the end of Exit Delay Time, 3 beeps will sound
ARMING
SIREN WARNING:
At the end of the exit time, all zones should
be Sealed. If any are Unsealed, the siren will
sound for 2 seconds as a warning to indicate
that those zones have been automatically
excluded. For maximum security, you should
return, Disarm, check the premises and then
Arm again. Continual warnings could mean
that a detector is faulty and may have to be
manually excluded.
If the auto-exclude option is disabled, the
siren will sound for the duration of reset time
if a zone is Unsealed at the end of exit time.
Technical Manuals Online! - http://www.tech-man.com
To Next Page
Loading...
Need help?
General
