UX2000 SBC XO SIP Trunk Lync Server 2010 Configuration Guide
8
3 Completing SIP Trunk Task on UX2000
Configuring the UX2000 is done through the UX2000s integrated web server. This guide assumes that the
operator has already done the initial configuration positioning the UX2000 on the IP network. To start the
configuration process use a standard web browser to connect to the IP or FQDN address of the UX2000.
Supply the username and password to complete the login process.
3.1 Prerequisites
The following will be required to complete the configuration of the UX2000 SIP Trunk Task:
a. Access to the Certificate Authority to download the root certificate and sign and download the user
certificate for the proper TLS operation between the UX2000 and the Lync 2010 Server(s)
b. FQDN of the Lync 2010 Mediation Server or Server pool
c. IP Address(s) of the XO Communications SIP Signalling destination server
d. FQDN of the UX2000
3.2 Initial Task configuration
The Initial Task configuration is a step by step process that will complete the steps to position the UX2000
between XO’s SIP Trunk and Microsoft’s Lync Server 2010. This task will install the necessary TLS
Certificates and create SIP components and call routing basics.
To Next Page
Loading...