EXPMT 2000 User Manual/R5
9
Test Setup
Introduction
Prior to the initial operation, make sure to charge the built-in Li-ion
battery by plugging in the
Charger
to the battery input Jack. The
battery charging status is indicated by the yellow
LED
next to
the
input jack. It takes 3-4 hours to fully charge the battery.
When
the
battery is fully charged the
Red LED
on the
Charger
will turn Green.
The
Analyzer
can be turned
ON
by momentarily pressing the “ON”
key. Pressing and holding the
ON
key for a few moments will
turn
the unit OFF.
When the unit is first powered, the screen momentarily shows the
software version and the build number. It will then will display
the
Main Menu as shown
below
.
In this menu the active keys are
F1, F2, F3,
F4 and
“>”
To Next Page
Loading...
