The Setup Wizard performs a full scan, which might take up to six minutes.
10. (Only if the page in the following figure displays) Specify how to manage problems with the detection
of the Internet connection.
The page that might display states that a problem occurred while the wizard was detecting the Internet
connection. If this page does not display, continue with Step 11.
Take one of the following actions:
• If you need to power cycle the modem, do so now:
a. Unplug your modem’s power, leaving the modem connected to the wall jack for your Internet
service.
b. Wait 10 seconds.
c. Plug in your modem’s power and turn on your modem.
d. Wait two minutes.
e. Select the I just power cycled the modem and waited for 2 minutes radio button.
f. Click the Next button.
• If you do not need to power cycle the modem, do the following:
a. Select the None of the above radio button.
b. Click the Next button.
The Ethernet cable information that is shown in the previous figure does not apply to
the modem.
Note
Manage the Internet Settings Manually
27
Broadband High-Speed DSL Modem Model DM200
To Next Page
Loading...
