Configure Switching
135
NETGEAR 24-Port Gigabit Smart Managed Pro Switch with PoE+ and 2 SFP Ports Model GS724TPv2
8. Click the Apply button.
The updated configuration is sent to the switch. Configuration changes take effect
immediately.
9. To refresh the page with the latest information about the switch, click the Update button.
The following table describes the nonconfigurable information on the page.
Configure IGMP Snooping for Interfaces
 To configure IGMP snooping for interfaces:
1. Connect your computer to the same network as the switch.
You can use a WiFi or wired connection to connect your computer to the network, or
connect directly to a switch that is off-network using an Ethernet cable.
2. Launch a web browser.
3. In the address field of your web browser, enter the IP address of the switch.
If you do not know the IP address of the switch, see Change the Default IP Address of the
Switch on page 9.
The login window opens.
4. Enter the switch’s password in the Password field.
The default password is password.
The System Information page displays.
5. Select Switching > Multicast > IGMP Snooping > IGMP Snooping Interface
Configuration.
Table 32. IGMP Snooping Configuration information
Field Description
Multicast Control Frame Count The number of multicast control frames that are processed by the CPU.
Interfaces Enabled for IGMP
Snooping
A list of all the interfaces currently enabled for IGMP snooping.
VLAN IDs Enabled For IGMP
Snooping
Displays VLAN IDs enabled for IGMP snooping.
VLAN IDs Enabled For IGMP
Snooping Querier
Displays VLAN IDs enabled for IGMP snooping querier.
To Next Page
Loading...
Need help?
General