Configure Quality of Service
172
NETGEAR 24-Port Gigabit Smart Managed Pro Switch with PoE+ and 2 SFP Ports Model GS724TPv2
The following table describes the nonconfigurable information on the page.
Rename an Existing DiffServ Policy
 To rename an existing DiffServ policy:
1. Connect your computer to the same network as the switch.
You can use a WiFi or wired connection to connect your computer to the network, or
connect directly to a switch that is off-network using an Ethernet cable.
2. Launch a web browser.
3. In the address field of your web browser, enter the IP address of the switch.
If you do not know the IP address of the switch, see Change the Default IP Address of the
Switch on page 9.
The login window opens.
4. Enter the switch’s password in the Password field.
The default password is password.
The System Information page displays.
5. Select QoS > DiffServ > Advanced > Policy Configuration.
The Policy Configuration page displays.
6. Select the check box next to the policy name.
7. In the Policy Name field, specify the new name.
8. Click the Apply button.
The updated configuration is sent to the switch. Configuration changes take effect
immediately.
Change the Policy Attributes for an Existing DiffServ Policy
 To change the policy attributes for an existing DiffServ policy:
1. Connect your computer to the same network as the switch.
You can use a WiFi or wired connection to connect your computer to the network, or
connect directly to a switch that is off-network using an Ethernet cable.
2. Launch a web browser.
Table 39. DiffServ policy configuration policy attributes
Field Description
Policy Name Displays the name of the DiffServ policy.
Policy Type Displays type of the policy as In.
Member Class Name Displays the name of the class instance within the policy.
To Next Page
Loading...
Need help?
General