Manage Device Security
190
NETGEAR 24-Port Gigabit Smart Managed Pro Switch with PoE+ and 2 SFP Ports Model GS724TPv2
6. In the Key String field, specify the authentication and encryption key for TACACS+
communications between the switch and the TACACS+ server.
The valid range is 0–128. The key must match the key configured on the TACACS+
server.
7. In the Connection Timeout field, specify the maximum number of seconds allowed to
establish a TCP connection between the switch and the TACACS+ server.
8. Click the Apply button.
The updated configuration is sent to the switch. Configuration changes take effect
immediately.
Configure a TACACS+ Server on the Switch
You can configure up to five TACACS+ servers with which the switch can communicate.
 To configure a TACACS+ server on the switch:
1. Connect your computer to the same network as the switch.
You can use a WiFi or wired connection to connect your computer to the network, or
connect directly to a switch that is off-network using an Ethernet cable.
2. Launch a web browser.
3. In the address field of your web browser, enter the IP address of the switch.
If you do not know the IP address of the switch, see Change the Default IP Address of the
Switch on page 9.
The login window opens.
4. Enter the switch’s password in the Password field.
The default password is password.
The System Information page displays.
5. Select Security > Management Security > TACACS+ > TACACS+ Server Configuration.
6. In the TACACS+ Server field, enter the TACACS+ server IP address.
7. In the Priority field, specify the priority for the TACACS+ server.
To Next Page
Loading...
Need help?
General