Manage Device Security
196
NETGEAR 24-Port Gigabit Smart Managed Pro Switch with PoE+ and 2 SFP Ports Model GS724TPv2
If you do not know the IP address of the switch, see Change the Default IP Address of the
Switch on page 9.
The login window opens.
4. Enter the switch’s password in the Password field.
The default password is password.
The System Information page displays.
5. Select Security > Access > HTTPS > HTTPS Configuration.
6. Select the HTTPS Admin Mode Enable or Disable radio button.
This enables or disables the administrative mode of secure HTTP (HTTPS). The
configured value is displayed. The default is Disable. You can download SSL certificates
only when the HTTPS admin mode is disabled. HTTPS admin mode can be enabled only
if a certificate is present on the device.
7. Select the TLS Version 1 Enable or Disable radio button.
This enables or disables Transport Layer Security version 1.0. The configured value is
displayed. The default is Enable.
8. In the HTTPS Port field, type the HTTPS port number.
The value must be in the range of 1025 to 65535. Port 443 is the default port. The
configured value is displayed.
9. In the HTTPS Session Soft Timeout (Minutes) field, enter the inactivity time-out for HTTPS
sessions.
The value must be in the range of 1 to 60 minutes. The default is 5 minutes. The
configured value is displayed.
10. In the HTTPS Session Hard Timeout (Hours) field, set the hard time-out for HTTPS
sessions.
This time-out is unaffected by the activity level of the session. The value must be in the
range of 1 to 168 hours. The default is 24 hours.
11. In the Maximum Number of HTTPS Sessions field, enter the maximum allowable number
of HTTPS sessions.
The value must be in the range of 0 to 4. The default is 4.
12. Click the Apply button.
To Next Page
Loading...
Need help?
General