Manage Device Security
217
NETGEAR 24-Port Gigabit Smart Managed Pro Switch with PoE+ and 2 SFP Ports Model GS724TPv2
7. Specify the following settings:
• Port Security. Enable or disable the port security feature for the selected interfaces
The default is Disable.
• Max Learned MAC Address. Specify the maximum number of dynamically learned
MAC addresses on the selected interfaces.
• Max Static MAC Address. Specify the maximum number of statically locked MAC
addresses on the selected interfaces.
• Enable Violation Traps. Enable or disable the sending of new violation traps if a
packet with a disallowed MAC address is received. The default is No, which means
that the option is disabled.
8. Click the Apply button.
The updated configuration is sent to the switch. Configuration changes take effect
immediately.
View Learned MAC Addresses and Convert Them to Static MAC Addresses
You can convert a dynamically learned MAC address to a statically locked address.
 To view learned MAC addresses for an individual interface or LAG and convert these
MAC addresses to static MAC addresses:
1. Connect your computer to the same network as the switch.
You can use a WiFi or wired connection to connect your computer to the network, or
connect directly to a switch that is off-network using an Ethernet cable.
2. Launch a web browser.
3. In the address field of your web browser, enter the IP address of the switch.
If you do not know the IP address of the switch, see Change the Default IP Address of the
Switch on page 9.
The login window opens.
4. Enter the switch’s password in the Password field.
The default password is password.
The System Information page displays.
5. Select Security > Traffic Control > Port Security > Port Security Configuration.
The Port Security Configuration page displays.
6. Make sure that port security is globally enabled.
For more information, see Configure the Global Port Security Mode on page 214.
7. Select Security > Traffic Control > Port Security > Interface Configuration.
The Interface Configuration page displays.
8. Make sure that port security is enabled for the individual interface for which you want to view
the dynamically learned MAC addresses.
To Next Page
Loading...
Need help?
General