NETGEAR GS724TPv2 User Manual

Configure System Information
83
NETGEAR 24-Port Gigabit Smart Managed Pro Switch with PoE+ and 2 SFP Ports Model GS724TPv2
Configure the Global DHCP Snooping Settings
You can view and configure the global settings for DHCP snooping.
 To configure the global DHCP snooping settings:
1. Connect your computer to the same network as the switch.
You can use a WiFi or wired connection to connect your computer to the network, or
connect directly to a switch that is off-network using an Ethernet cable.
2. Launch a web browser.
3. In the address field of your web browser, enter the IP address of the switch.
If you do not know the IP address of the switch, see Change the Default IP Address of the
Switch on page 9.
The login window opens.
4. Enter the switch’s password in the Password field.
The default password is password.
The System Information page displays.
5. Select System > Services > DHCP Snooping > Global Configuration.
6. Next to DHCP Snooping Mode, select the Enable radio button.
7. To enable the verification of the sender’s MAC address for DHCP snooping, next to MAC
Address Validation, select the Enable radio button.
When MAC address validation is enabled, the device checks packets that are received on
an untrusted interface to verify that the MAC address and the DHCP client hardware
address match. If the addresses do not match, the device drops the packet.
8. Click the Apply button.
The updated configuration is sent to the switch. Configuration changes take effect
immediately.

NETGEAR GS724TPv2 Specifications

General

Brand	NETGEAR
Model	GS724TPv2
Category	Switch
Language	English