NETGEAR GS748T - ProSafe Smart Switch User Manual

GS748T Smart Switch Hardware Installation Guide
Introduction 1-3
v1.1, September 2007
• Auto-Discovery support with application program for discovering and managing the smart
switches on the network
• Flash upgrade, configuration backup/restore, and factory reset
• Full compatibility with IEEE standards:
• IEEE 802.3i (10BASE-T)
• IEEE 802.3u (100BASE-TX)
• IEEE 802.3z/ab (1000BASE-X, 1000Base-T)
• IEEE 802.3x (full-duplex flow control)
• Auto-sense and auto-negotiate for all ports
• Auto Uplink on all ports for the right connection sense
• Integrated address Look-Up Engine supports 8K absolute MAC addresses
• Full- and half-duplex functions for all 10/100/1000 ports
• Store-and-Forward transmission to remove bad packets from the network
• Active flow control to minimize packet loss/frame drops:
• Half-duplex back-pressure control
• Full-duplex IEEE 802.3x pause frame flow control
• LED indicators for port status monitoring:
• Power LED indicates power on/off status
• Link/Act LED indicates link status and activity
• SFP GBIC Link/Act LED indicates link status and activity
• Flexible installation:
• Standalone desktop installation
• 19-inch standard rack-mount
• Standard 1U case size

NETGEAR GS748T - ProSafe Smart Switch Specifications

General

Model	GS748T
Device Type	Smart Switch
SFP Slots	4
Form Factor	Rack-mountable
Switching Capacity	96 Gbps
MAC Address Table Size	8K entries
VLAN Support	Yes
QoS	Yes
Humidity	10% to 90% non-condensing
RAM	128 MB
Flash Memory	32 MB
Power Device	Internal power supply
Ports	48 x 10/100/1000
Management	Web-based
Operating Temperature	0 - 50 °C
Voltage Required	100-240 VAC
Compliant Standards	IEEE 802.3, IEEE 802.3u, IEEE 802.3ab, IEEE 802.3z
Features	VLAN support, QoS, port mirroring, SNMP