EasyManuals Logo

NETGEAR GS748T - ProSafe Smart Switch User Manual

NETGEAR GS748T - ProSafe Smart Switch
36 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #29 background imageLoading...
Page #29 background image
Troubleshooting A-1
v1.1, September 2007
Appendix A
Troubleshooting
This chapter provides information about troubleshooting the NETGEAR GS748T Gigabit Smart
Switch. Information is supplied as:
A Troubleshooting chart
Additional troubleshooting suggestions
Troubleshooting Chart
Table A-1 lists symptoms, causes, and solutions of possible problems.
Table A-1. Troubleshooting Chart
Symptom Cause Solution
Power LED is off No power is received Check the power cord connections for the switch at
the switch and the connected device
Make sure all cables used are correct and comply
with Ethernet specifications.
Link/ACT LED is off Port connection is not
working
Check the crimp on the connectors and make sure
that the plug is properly inserted and locked into the
port at both the switch and the connecting device.
Make sure all cables used are correct and comply
with Ethernet specifications. See Appendix D.
Check for a defective adapter card, cable, or port by
testing them in an alternate environment where all
products are functioning.
File transfer is slow or
performance
degradation is a
problem
Half- or full-duplex
setting on the switch
and the connected
device are not the same
Make sure the attached device is set to auto
negotiate.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the NETGEAR GS748T - ProSafe Smart Switch and is the answer not in the manual?

NETGEAR GS748T - ProSafe Smart Switch Specifications

General IconGeneral
ModelGS748T
Device TypeSmart Switch
SFP Slots4
Form FactorRack-mountable
Switching Capacity96 Gbps
MAC Address Table Size8K entries
VLAN SupportYes
QoSYes
Humidity10% to 90% non-condensing
RAM128 MB
Flash Memory32 MB
Power DeviceInternal power supply
Ports48 x 10/100/1000
ManagementWeb-based
Operating Temperature0 - 50 °C
Voltage Required100-240 VAC
Compliant StandardsIEEE 802.3, IEEE 802.3u, IEEE 802.3ab, IEEE 802.3z
FeaturesVLAN support, QoS, port mirroring, SNMP

Related product manuals