Nighthawk AC1900 WiFi Cable Modem Router
Supplemental Information User Manual93
Factory Settings
You can return the modem router to its factory settings. Use the end of a paper clip or a
similar object to press and hold the Reset button on the back of the modem router for at least
seven seconds. The modem router resets, and returns to the factory configuration settings
shown in the following table.
Table 2. Factory default settings
Feature Default behavior
Modem router
login
User login URL www.routerlogin.com or www.routerlogin.net
User name (case-sensitive) admin
Login password (case-sensitive) password
Local network
(LAN)
LAN IP 192.168.0.1
Subnet mask 255.255.255.0
DHCP server Enabled
DHCP range 192.168.0.2 to 192.168.0.254
Time zone Pacific time
DHCP starting IP address Configured by the Internet provider
DHCP ending IP address 192.168.0.254
DMZ Disabled
Time zone As per the ISP/MSO ToD (Time of Day) Configuration
Time zone adjusted for daylight
savings time
As per ISP/MSO ToD (time of Day) server configuration
SNMP Enabled
Cable modem
Firewall
Inbound (communications coming
in from the Internet)
Disabled (except traffic on port 80, the HTTP port)
Outbound (communications going
out to the Internet)
Enabled (all)
Wireless Wireless communication Enabled
SSID name See the product label
Security WPA2-PSK (AES)
Broadcast SSID Enabled
To Next Page
Loading...
Need help?
General
