NETGEAR Nighthawk Mesh WiFi 6 System User Manual

The satellite label also displays the WiFi network name and password, the satellite’s
MAC address, and the satellite’s serial number. The following is an example of what the
satellite label might look like:
Figure 4. Satellite label
Connect your router
Power on your router and connect it to a modem.
Figure 5. Connect your router
To connect your router:
1.
Unplug your modem’s power, leaving the modem connected to the wall jack for
your Internet service.
If your modem uses a battery backup, remove the battery.
2. Plug in and turn on your modem.
If your modem uses a battery backup, put the battery back in.
3.
Connect your modem to the Internet port of your router with the Ethernet cable that
came with your router.
4. Connect the power adapter to your router and plug the power adapter into an outlet.
User Manual12Overview
Nighthawk Mesh WiFi 6 System

NETGEAR Nighthawk Mesh WiFi 6 System Specifications

General

WiFi Technology	WiFi 6 (802.11ax)
Antennas	Internal antennas
MU-MIMO	Yes
OFDMA	Yes
Security	WPA3
Beamforming	Yes
Backhaul	Dedicated WiFi backhaul
Parental Controls	Yes
Guest Network	Yes
App Support	Nighthawk App
Coverage	Up to 4, 500 sq. ft.
Speed	Up to 1.8Gbps
Number of Nodes	2 or 3 (depending on the specific model)
Bands	Dual-band
Ports	Gigabit Ethernet
Ethernet Ports	1 WAN and 3 LAN Gigabit Ethernet ports per node
Processor	Quad-core processor
Compatibility	Works with any internet service provider