Page 19 of 19
APPENDIX A: DEFAULT SETTINGS
This appendix provides default settings for the NETGEAR Smart Switches. You can always configure the
switch to default settings by using the Factory Reset function from a Web browser.
Table A-1. Default Settings
FEATURE DEFAULT SETTING
Port Speed Auto-negotiation
Port Duplex Auto-negotiation
Flow Control (half duplex) Enabled
Flow Control (full duplex) Enabled
IP Configuration DHCP enabled
Password password
VLAN Port-Based VLAN
Link Aggregation (Trunk) Disabled
Traffic Prioritization (QoS) Optimized for flow control, all ports set normal priority
To Next Page
Loading...
