NETGEAR R7500

Connect an eSATA Device to the Router
You can connect an eSATA device to the eSATA port located on the right side of the router.
Figure 9. eSATA port
USB Device Requirements
The router works with most USB-compliant external flash and hard drives. For the most up-to-date list of
USB devices that the router supports, visit http://kbserver.netgear.com/readyshare.
Some USB external hard drives and flash drives require you to load the drivers onto the computer before
the computer can access the USB device. Such USB devices do not work with the router.
The router supports the following file system types for full read/write access:
• FAT16
• FAT32
• NTFS
• NTFS with compression format enabled
• Ext2
• Ext3
• Ext4
• HFS
• HFS+
Connect a USB Device to the Router
ReadySHARE lets you access and share a USB device connected to the router USB port. (If your USB
device uses special drivers, it is not compatible.)
Share Storage Devices Attached to the Router
65