NETGEAR WNDR4500v2

Advanced Settings
104
N900 Wireless Dual Band Gigabit Router WNDR4500v2
 To set up a static route:
1. Select Advanced > Advanced Setup > Static Routes, and click Add to display the
following screen:
2. In the Route Name field, type a name for this static route (for identification purposes only.)
3. Select the Private check box if you want to limit access to the LAN only
. If Private is
selected, the static route is not reported in RIP.
4. Select the Active check box to make this route ef
fective.
5. T
ype the IP address of the final destination.
6. T
ype the IP subnet mask for this destination. If the destination is a single host, type
255.255.255.255.
7. T
ype the gateway IP address, which has to be a router on the same LAN segment as the
router.
8. T
ype a number from 1 through 15 as the metric value.
This value represents the number of routers between your network and the destination.
Usually
, a setting of 2 or 3 works, but if this is a direct connection, set it to 1.
9. Click Apply to add the static route.