Wireless-N 150 Router WNR1000v2 User Manual
2-12 Safeguarding Your Network
v1.0, September 2009
The available settings in this screen are:
• Enable Wireless Router Radio. If you disable the wireless router radio, wireless devices
cannot connect to the WNR1000v2 router. If you will not be using your wireless network
for a period of time, you can clear this check box and disable all wireless connectivity.
• Enable SSID Broadcast. Clear this check box to disable broadcast of the SSID, so that
only devices that know the correct SSID can connect. Disabling SSID broadcast nullifies
the wireless network discovery feature of some products such as Windows XP.
• Enable WMM. Clear this check box to disable WMM. WMM (Wireless Multimedia), a
subset of the 802.11e standard, allows wireless traffic to have a range of priorities,
depending on the kind of data. Time-dependent information, like video or audio, will have
a higher priority than normal traffic. For WMM to function correctly, Wireless clients
must also support WMM.
• Fragmentation Threshold, CTS/RTS Threshold, and Preamble Mode. The
Fragmentation Threshold, CTS/RTS Threshold, and Preamble Mode options are reserved
for wireless testing and advanced configuration only. Do not change these settings.
• WPS Settings. For information about these settings, see the section, “Using Push 'N'
Connect (Wi-Fi Protected Setup)” on page 2-13.
• Wireless Card Access List. For information about this list, see “Restricting Wireless
Access by MAC Address” on page 2-18.
Figure 2-5
To Next Page
Loading...
Need help?
General
