Wireless-N 150 Router WNR1000v2 User Manual
Safeguarding Your Network 2-15
v1.0, September 2009
The green light on the WNR1000v2 router begins to blink in a regular pattern. While the
button light is blinking, you have 2 minutes to enable WPS on the device you are trying to
connect to the router.
5. In the wireless client, follow its specific networking instructions to enable WPS, to allow it to
connect to the router.
The WNR1000v2 router’s green light ceases blinking and remains on when one of these
conditions occurs:
• The router and the client establish a wireless connection.
• The 2-minute window period expires for establishing a WPS connection. If the connection
is not established, no WPS security settings will be specified in the WNR1000v2 router.
Security PIN Entry
There are two ways to enable a wireless client to join a network using a PIN: using the router’s
security PIN or using the wireless client’s security PIN.
Using the Router’s Security PIN
1. Obtain your router’s security PIN from the rear panel of the router or from the Advanced
Wireless Settings screen.
2. On the wireless client, follow its specific networking instructions to enter the router’s security
PIN and to establish a wireless connection with the router.
Using the Wireless Client’s Security PIN
1. Log in to the router as described in “Logging In To Your Wireless Router” on page 1-2.
2. Select Add WPS Client in the main menu, and click Next.
3. Select the PIN Number setup method.
To Next Page
Loading...
Need help?
General
