NETGEAR WNR1000v3 - Wireless- N Router - Page 46

Wireless-N 150 Router WNR1000v3 User Manual
Safeguarding Your Network 2-19
v1.0, February 2010
ipconfig/all command in an MSDOS command prompt window displays the MAC address as
Physical Address. You might also find the MAC addresses in the router’s Attached Devices
screen.
To restrict access based on MAC addresses:
1. Select Wireless Settings under Advanced in the main menu.
2. In the Advanced Wireless Settings screen, click Setup Access List to display the Wireless
Card Access List.
3. Click Add to add a wireless device to the wireless access control list. The Wireless Card
Access Setup screen opens and displays a list of currently active wireless cards and their MAC
addresses.
Figure 2-11
Figure 2-12