150Mbps Wireless-N Outdoor AP User Manual
4.3.1.7 Advanced
These settings are only for more technically advanced users who have a sufficient knowledge
about wireless LAN. These settings should not be changed unless you know what effect the
change will have on your AP.
Figure 4-25
Ø Authentications type: The default is set to “Auto”, which allows “Open System” or “Shared
Key” authentication to be used. Select “Shared Key” if you only want to use “Shared Key”
authentication (the sender and recipient use a WEP key for authentication).
Ø Beacon Interval: The interval time of this 150Mbps Wireless-N Gigabit Router broadcast a
beacon. Beacon is used to synchronize the wireless network. The valid interval is 20-1000,
the default is 100.
Ø RTS Threshold: You can set RTS Threshold value in this field, the valid range should be
256-2347 and default value is 2347. If a network packet is smaller than the preset RTS
threshold size, the RTS/CTS mechanism will not be enabled.
Ø Aggregation: You can accelerate the wireless transmission speed by enabling the aggregation
function. The default is AMPDU＋AMSDU.
Ø Fragmentation Threshold: It specifies the maximum size of packet during the fragmentation
of data to be transmitted.
Ø Transmission Rate: Transmit rate indicates the transmission speed of wireless LAN
To Next Page
Loading...
Need help?
General
