NetModule NB2800 - Ipsec

NB2800
User Manual for NRSW version 4.5.0.100
5.4.7. OSPF
The OSPF tab allows the NetModule router to be added to a network of OSPF routers.
Parameter OSPF General Settings
OSPF status Specifies whether the OSPF routing protocol is active
Redistribute connected
routes
Redistribute routes to networks which are directly connected to the
NetModule router
Redistribute local routes Redistribute routes from the NetModule router’s own routing table
Redistribute BGP routes Redistribute routes learned via the BGP routing protocol
Redistribute default route Redistribute the routers default route
Disable BGP when VRRP
slave
Disables the OSPF protocol when the router is set to slave mode by
the VRRP redundancy protocol
The interfaces tab is used to define OSPF specific settings for the IP interfaces of the router. If no
settings are defined for a specific interface, default settings will be used.
Parameter OSPF Interfaces
Interface The name of the interface for which settings shall be defined
Authentication The authentication protocol to be used on the interface to authenticate
OSPF packets
Key The key to be used for authentication
Key ID The ID of the key to be used for authentication (1-255)
Cost The cost for sending packets via this interface. If not specified or set
to 0 OSPF defaults are used.
Passive Do not send out OSPF packets on this interface
The networks tab defines the IP networks to be handled in OSPF as well as to which routing area they
belong.
Parameter OSPF Networks
Prefix Prefix of the network
Prefix length Length of the prefix
Area Routing area to which this interface belongs (0-65535, 0 means back-
bone)
100