NetModule NB2800 - Default LED Indicators; Reset; NB800 (Rev. B02) Status Indicators; Ethernet Status Indicators

NB2800
User Manual for NRSW version 4.5.0.100
Nr. Label Panel Function
11 MOB 3/ WLAN 2 Rear 2 FAKRA coding I/D jacks for MIMO WLAN 2 or MIMO LTE an-
tenna
12 A8 Rear Auxiliary port
13 MOB 4/ WLAN 1 Rear 2 FAKRA coding I/D jacks for MIMO WLAN or MIMO LTE an-
tenna
14 EXT Rear Audio/CAN/IBIS/RS-232/RS-485/Audio-PTT extension.
Table 3.2.: NB2800 Interfaces
3.4.2. LED Indicators
The following table describes the NB2800 status indicators.
Label Color State Function
STAT l blinking The device is busy due to startup, software or configuration up-
date.
l on The device is ready. The captions of the top bank apply.
l on The device is ready. The captions of the bottom bank apply.
MOB1 lll
[1]
on Mobile connection 1 is up.
l blinking Mobile connection 1 is being established.
m off Mobile connection 1 is down.
MOB2 lll
[1]
on Mobile connection 2 is up.
l blinking Mobile connection 2 is being established.
m off Mobile connection 2 is down.
VPN l on VPN connection is up.
m off VPN connection is down.
WLAN1 lll
[1]
on WLAN 1 connection is up.
l blinking WLAN 1 connection is being established.
m off WLAN 1 connection is down.
WLAN2 lll
[1]
on WLAN 2 connection is up.
l blinking WLAN 2 connection is being established.
m off WLAN 2 connection is down.
GNSS l on GNSS is turned on and a valid NMEA stream is available.
l blinking GNSS is searching for satellites.
m off GNSS is turned off or no valid NMEA stream is available.
VOICE l on A voice call is currently active.
m off No voice call is active.
18