NB2800
User Manual for NRSW version 4.5.0.100
Label Color State Function
USR1-5 l on User defined.
m off User defined.
EXT1 l on Extension port 1 is on.
m off Extension port 1 is off.
EXT2 l on Extension port 2 is on.
m off Extension port 2 is off.
[1]
The color of the LED represents the signal quality for wireless links.
l red means low
l yellow means moderate
l green means good or excellent
Table 3.3.: NB2800 Status Indicators
Ethernet LEDs
The following table describes the Ethernet status indicators.
Label Color State Function
S l 1 blink 10 Mbit/s
l 2 blinks 100 Mbit/s
l 3 blinks 1000 Mbit/s
m off no Link
L/A l on Link on
l blinking Activity
m off no Link
Table 3.4.: Ethernet Status Indicators
3.4.3. Reset
The reset button has two functions:
1. Reboot the system:
Press at least 3 seconds to release a system reboot.
The reboot is indicated with the red blinking STAT LED.
2. Factory reset:
Press at least 10 seconds to release a factory reset.
The start of the factory reset is confirmed by all LEDs lighting up for a second.
19
To Next Page
Loading...
