NB2800
User Manual for NRSW version 4.5.0.100
WLAN IP Settings
This section lets you configure the TCP/IP settings of your WLAN network. A client interface can be
run over DHCP or with a statically configured address and default gateway.
NetModule Router Simulator
Hostname NB1600
Software Version 4.4.0.103
© 2004-2020, NetModule AG
WAN
Link Management
Supervision
Settings
Ethernet
Port Setup
VLAN Management
IP Settings
Mobile
Modems
SIMs
Interfaces
WLAN
Administration
Configuration
IP Settings
Bridges
USB
Serial
Digital I/O
GNSS
WLAN1 IP Settings
Network mode:
bridged
routed
IP address:
HOME INTERFACES ROUTING FIREWALL VPN SERVICES SYSTEM
LOGOUT
Figure 5.14.: WLAN IP Configuration
The access point networks can be bridged to any LAN interface for letting WLAN clients and Ethernet
hosts operate in the same subnet. However, for multiple SSIDs we strongly recommend to set up
separated interfaces in routing-mode in order to avoid unwanted access and traffic between the inter-
faces. The corresponding DHCP server for each network can be configured in afterwards as described
in chapter 5.7.2.
Parameter WLAN IP Settings
Network mode Choose whether the interface shall be operated bridged or in routing-
mode
Bridge interface If bridged, the LAN interface to which the WLAN network should be
bridged
IP address / netmask In routing-mode, the IP address and netmask for this WLAN network
74
To Next Page
Loading...
