NB2800
User Manual for NRSW version 4.5.0.100
USB Devices
This page show the currently connected devices and it can be used to enable a specific device based
on its Vendor and Product ID. Only enabled devices will be recognized by the system and raise addi-
tional ports and interfaces.
Administration Devices Autorun
NetModule Router Simulator
Hostname NB1600
Software Version 4.4.0.103
© 2004-2020, NetModule AG
WAN
Link Management
Supervision
Settings
Ethernet
Port Setup
VLAN Management
IP Settings
Mobile
Modems
SIMs
Interfaces
WLAN
Administration
Configuration
IP Settings
Bridges
USB
Serial
Digital I/O
GNSS
Connected USB Devices
Vendor ID Product ID Bus ID Manufacturer Device Type
Enabled USB Devices
Vendor ID Product ID Bus ID Module Type Attached
HOME INTERFACES ROUTING FIREWALL VPN SERVICES SYSTEM
LOGOUT
Figure 5.16.: USB Device Management
Parameter USB Devices
Vendor ID The USB Vendor ID of the device
Product ID The USB Product ID of the device
Module The USB module and type of driver to be applied for this device
Any ID must be specified in hexadecimal notation, wildcards are supported (e.g. AB[0-1][2-3] or AB*)
A USB network device will be referenced as LAN10.
78
To Next Page
Loading...
