NB2800
User Manual for NRSW version 4.5.0.100
The following commands are supported:
Command Action
status Will reply a message to the sender including a short system overview
connect Will enable the first WAN link configured on the system
disconnect Will disable the first WAN link configured on the system
reboot Initiates a reboot of the system
output 1 on Turns on the first digital output port
output 1 off Turns off the first digital output port
output 2 on Turns on the second digital output port
output 2 off Turns off the second digital output port
Table 5.95.: SMS Control Commands
A response to the status command typically looks like:
System: NB2700 hostname (00:11:22:AA:BB:CC)
WAN1: WWAN1 is up (10.0.0.1, Mobile1, UMTS, -83 dBm, LAI 12345)
GPS: lat 47.377894, lon 8.540055, alt 282.200
OVPN: client on tun0 is up (10.0.8.4)
DIO: IN1=off, IN2=off, OUT1=on, OUT2=off
135
To Next Page
Loading...
