NetModule NB2800 - Factory Configuration

NB2800
User Manual for NRSW version 4.5.0.100
−v validate config parameter
−f get factory default rather than current value
−c show configuration sections
6.4. Setting Config Parameters
The set command can be used to set configuration values.
> set −h
Usage :
set [−hv ] <parameter >=<value > [ < parameter >=<value > . . ]
Options :
−v validate config parameter
6.5. Checking Config Completed
The done command can be used to check if all modify scripts have completed after a config change.
> done −h
Usage :
done [−h ]
6.6. Getting Status Information
The status command can be used to get various status information of the system.
> status −h
Usage :
status [−hs ] <section >
Options :
−s generate sourceable output
Available sections :
summary Short status summary
info System and config information
config Current configuration
system System information
configuration Configuration information
license License information
wwan WWAN module status
wlan WLAN module status
gnss GNSS ( GPS ) module status
eth Ethernet interface status
lan LAN interface status
wan WAN interface status
openvpn OpenVPN connection status
203