NB2800
User Manual for NRSW version 4.5.0.100
5.6.6. Dial-In
On this page you can configure the Dial-In server in order to establish a data connection over GSM
calls. Thus, one would generally apply a required service type of 2G-only, so that the modem registers
to GSM only. Naturally, a concurrent use of outgoing WWAN interfaces and Dial-In connection is not
possible.
Figure 5.35.: Dial-in Server Settings
The following settings can be set:
Parameter Dial-in Server Configuration
Administrative status Specifies whether incoming calls shall be answered or not
Modem Specifies the modem on which calls can come in
User Specifies the username for the incoming PPP connection
Password Specifies the password for the incoming PPP connection
Address range start Start of the IP address range assigned to incoming clients
Address range size Number of addresses for client IP address range
125
To Next Page
Loading...
