NB2800
User Manual for NRSW version 4.5.0.100
Let’s now pay some attention to the very powerful API function nb_status. It can be used to query the
router’s status values in the same manner as they can be shown with the CLI. It returns a structure of
variables for a specific section (a list of available sections can be obtained by running cli status -h).
By using the dump function you can figure out the content of the returned structure:
/* dump cur rent location */
dump ( nb_stat us (" locati on "));
The script will then generate lines like maybe these:
struct(8): {
.LOCATION_STREET = string[11]: "Bahnhofquai"
.LOCATION_CITY = string[10]: "Zurich"
.LOCATION_COUNTRY_CODE = string[2]: "ch"
.LOCATION_COUNTRY = string[11]: "Switzerland"
.LOCATION_POSTCODE = string[4]: "8001"
.LOCATION_STATE = string[6]: "Zurich"
.LOCATION_LATITUDE = string[9]: "47.3778058"
.LOCATION_LONGITUDE = string[8]: "8.5412757"
}
In combination with the nb_config_set function, it is possible to start a re-configuration of any parts
of the system upon status changes. You may query possible sections and parameters again with the
CLI:
~ $ cli get -c wanlink.0
cli get -c wanlink.0
Showing configuration entities (matching ’wanlink.0’):
wanlink.0.mode wanlink.0.multipath wanlink.0.name
wanlink.0.options wanlink.0.passthru wanlink.0.prio
wanlink.0.suspend wanlink.0.switchback wanlink.0.weight
Running the CLI in interactive mode, you will be also able to step through possible configuration pa-
rameters by the help of the TAB key.
129
To Next Page
Loading...
