NB2800
User Manual for NRSW version 4.5.0.100
5.7.4. NTP Server
This section can be used to individually configure the Network Time Protocol (NTP) server function.
NetModule Router Simulator
Hostname NB1600
Software Version 4.4.0.103
© 2004-2020, NetModule AG
SDK
Administration
Job Management
Testing
DHCP Server
DNS Server
NTP Server
Dynamic DNS
E-mail
Events
SMS
SSH/Telnet Server
SNMP Agent
Web Server
Softflow
Discovery
Redundancy
Voice Gateway
NTP Server Administration
Administrative status:
enabled
disabled
NTP Server Configuration
Poll interval:
seconds
Allowed hosts:
Address:
HOME INTERFACES ROUTING FIREWALL VPN SERVICES SYSTEM
LOGOUT
Figure 5.40.: NTP Server
The following settings for each interface can be applied then:
Parameter NTP Server Settings
Administrative status Specifies whether the NTP server is enabled or not
Poll interval Defines the polling interval (64..2048 seconds) for synchronizing the
time with the master clock servers
Allowed hosts Defines the IP address range which is allowed to poll the NTP server
For setting the system time of the device see 5.8.1.
141
To Next Page
Loading...
