NetModule NB2800 - Page 237

NB2800
User Manual for NRSW version 4.5.0.100
A.5. SDK Examples
Event Description
best-operator.are This script will scan for operators on startup and choose the one with
the best signal
candump.are This script can be used to receive CAN messages
config-summary.are This script shows a summary of the currently running configuration.
dio.are This script can be used to set a digital output port.
dio-monitor.are This script monitors the DIO ports and sends a SMS to the specified
phone number.
dio-server.are This script implements a TCP server which can be used to control the
DIO ports.
dynamic-operator.are This script will scan Mobile2 and dial the appropriate SIM on Mobile1
email-to-sms.are This script implements a lightweight SMTP server which is able to
receive mail and forward them as SMS to a phone number.
etherwake.are This script can be used to wake up a sleeping host (WakeOnLan)
gps-broadcast.are This script sends the local GPS NMEA stream to a remote UDP server
(incl. device identity).
gps-monitor.are A script for activating WLAN as soon as GPS position (lat,lon) is within
a specified range.
gps-udp-client.are This script sends the local GPS NMEA stream to a remote UDP
server.
gps-udp-client-compat.are This script sends the local GPS NMEA stream (incl. serial/checksum)
to a remote UDP server.
led.are This script can be used to set a LED
modbus-rtu-master.are This script can be used to read messages from the serial port.
modbus-rtu-slave.are This script implements a modbus slave server
modbus-tcp-rtu-gateway.are This script implements a Modbus TCP RTU gateway
mount-media.are This script can be used to mount an USB storage stick.
opcua-browse.are This script will browse for nodes at a remote OPC-UA server.
opcua-json.are This script polls any temperature nodes of an OPC-UA server and
sends them JSON-encoded to a remote server.
opcua-read.are This script will read the node value at a OPC-UA server.
opcua-write.are This script will write a new value to a node at a OPC-UA server.
ping-supervision.are This script will supervise a specified host.
read-config.are This script can be used to read a configuration parameter.
237