Wireless Router Mode
Connects to a DSL or cable modem and functions
as an N300 Wireless router.
● Use anywhere a router is needed to
connect to a modem and create a wireless
internet network.
Setup Steps:
1. Write down the SSID and Passphrase
located on the label under your ezLINQ.
2. Plug the ezLINQ to an electrical outlet.
3. Use the blue ethernet cable to connect
your internet modem to the blue ezLINQ
port labeled “INTERNET”.
4. Wait for the LED light to turn solid blue.
5. The ezLINQ broadcasts its own WiFi signal
with an SSID label.
6. Connect your WiFi-enabled devices to this
SSID. Enter the passphrase for the SSID.
7. Your WiFi-enabled devices should now
have internet access.
To Next Page
Loading...
Need help?
General
