Repeater Mode
Receives and broadcasts your existing wireless
signal to extend wireless range (the network SSID
and password will not change). This mode is
especially useful for covering areas that receive
little or no wireless signal strength.
● Use in a large house, office, warehouse or
anywhere the existing signal is weak and
unstable.
Setup Steps:
1. Write down the SSID and Passphrase
located on the label under your ezLINQ.
2. Plug the ezLINQ to an electrical outlet.
3. Use the TALK App to connect the ezLINQ
to a WiFi network with internet access.
4. Wait for the LED light to turn solid blue.
5. The ezLINQ broadcasts its own WiFi
signal with an SSID label.
6. Connect your WiFi-enabled devices to this
SSID. Enter the passphrase for the
SSID.
7. Your WiFi-enabled devices should now
have internet access.
8. You can also connect an
ethernet-enabled device to the yellow
ezLINQ port labeled “ETHERNET”.
9. You ethernet-enabled device should now
have internet access too.
To Next Page
Loading...
Need help?
General
