NetTalk ezLINQ User Manual

Table of Contents
Table of Contents 1
What’s inside the Box? 3
ezLINQ: First Time Setup Overview 4
1. Activate (netTALK ID required) 4
2. Setup (handset phone and internet required) 4
3. Configure (iOS or Android device required) 4
How to activate your netTALK VoIP phone service. 5
How to connect a standard handset phone to the ezLINQ 5
How to assign an active VoIP phone service to the ezLINQ. 7
How to connect the ezLINQ to your home or office WiFi network. 8
How to connect the ezLINQ to your home or office internet using the ethernet port. 9
Connect to a modem 9
Connect to a router 9
How to setup different router modes 11
How to setup Wireless Router Mode (default mode) 11
(Create a WiFi network) 11
How to setup Client Mode (TV/Game Console/etc) 12
(Make any Ethernet-enabled device WiFi-enabled) 12
How to setup Repeater Mode 13
(Eliminate WiFi Dead Zones) 13
How to setup Access Point Mode 14
(Convert a Wired Network to a WiFi Network) 14
How to setup WISP Client Router Mode 15
(Create a WiFi Hotspot) 15
How to use the ezLINQ’s USB port 16
USB: Charge your phone 16
USB: Create a network drive 16
USB: Stream media on your network 16
How to access the USB Flash Drive 16
How to reset your ezLINQ to default factory settings 17
1

NetTalk ezLINQ Specifications

General

Brand	NetTalk
Model	ezLINQ
Category	Wireless Router
Language	English