To Hide chars of barcode Start/Middle/End:
Procedures
1. Scan the Hide Barcode Start / Middle Start / Middle length / End Chars symbol.
2. Determine the hex value for the length you wish to enter(hide 4 chars, scan 0,4; hide 12 chars, scan 0,C).
3. Scan the 2 digit hex value from the Numeric Bar Codes
4. Scan the output format to enable or cancel hide char function.
Custom prefix and suffix
Maximum 20 prefixes and 20 suffixes can be added to scan data for use in data editing. To set these values,
scan a double-digit hexadecimal number (i.e. two bar codes) that corresponds to ASCII values. See the Table 1
and Numeric Bar Codes in appendix.
To Add a Prefix or Suffix:
1. Scan command barcode of " Add Prefix" or" Add Suffix ".
2. Check the prefix or suffix hex value from the ASCII Chart.
3. Scan the 2 digit hex value from the Numeric Bar Codes
4. Repeat Steps 2 and 3 for all the prefix or suffix that you want to add.
5. Scan the output format to enable or disable prefix/suffix output.
Add Prefix
Add Suffix
Clear All Prefix
Clear All Suffix
Numeric Bar Codes
To Next Page
Loading...
Need help?
General
