4. If connection fails, unplug the base and repeat the above steps.
Starting wireless scanning
Scan the code “start wireless scanning” on the association cards or page 11 of the
guide book.
Understanding the features
Audio and visual indications during data transmission:
Low power alarm:
In case of instant auto-shutdown after startup, please charge the battery as the power
is low.
Charging:
Please fully charge the battery for first time use. Shut down the scanner before
charging. When the reader/terminal is on charge, both the blue and the red lights on
the base will be on. When charging is finished, only the red one will be on.
Operating the scanner
Before you start scanning, make sure:
• The terminal has adequate power .
• The scanner, cable and the Host are connected.
• All cable connections from the base station are secure.
To scan bar codes
1. Aim the scanner at a slight angle or pitch to the bar code and press the trigger.
2. If you did not get a good read, adjust the scanner distance from the bar code and
the position of the scan beam to make sure you scan every bar and space. The
optimum reading stance between scanner and barcode is 15-20 cm.
3. On a successful read, there’ll be a beep sound, beam dies out. The scanner then
To Next Page
Loading...
Need help?
General
