transmits barcode message to the Host.
4. To instantly upload data, please make sure that the terminal is in range and
associated to the base, or program will automatically turn into storage mode. The
terminal communicates with the base at long distance of 150 meters indoor or 300
meters outdoor.
Configuring the scanner
Play around in the settings menu to configure the device to your exact
specifications.
Scan this code to enter
normal scanning mode.
Under this mode, data will
be transmitted to the base
upon scan.
(defaulted)
The scanner emits 1 beep and the
blue light flashes once when the
base successfully receives
signals.
The scanner emits 3 beep and the
blue indicator flashes 3 times
when the base is not successfully
associated with scanner. The
scan result will be automatically
stored in the scanner.
Storage mode will be activated
to replace normal mode when
the base fails 3 times in a row
receiving a signal.
To Next Page
Loading...
Need help?
General
