ChipSHOUTER Users Manual: Serial Interface
54
[get / set] hwtrig_term [1/0] [g / s] hwt
Configure hardware trigger (SMB connector) as high
impedance [0] or 50Ω [1]. The 50Ω impedance option
puts a 50Ω resistor to ground. If you are not us-
ing the hardware trigger it is suggested to set
this ON, as it will reduce potential noise on the
hardware trigger causing glitches.
[get / set] hwtrig_mode [1/0] [g / s] hwm
Configure hardware trigger (SMB connector) as ac-
tive high [1] or active low [0]. When configured
as active low ensure the pin is externally driven
high during operation to prevent false triggers.
This command switches the entire internal trigger
logic. When switching hwtrig_mode and using the
pattern trigger, you will need to invert the pat-
tern trigger logic.
[get / set] emode [1/0] [g / s] e
Use pin 2 on RJ12 connector as either arm [0] or
firmware trigger [1]. Note this pin is NOT the
hardware trigger input.
[get / set] mute [1/0] [g / s] m
Mute the internal buzzer, good for automated test-
ing and avoiding beeping driving you crazy.
[get / set] bootbits [g / s] bb
Configure bootloader mode, only for firmware up-
grades.
get fault g f
Print the current state of all faults.
To Next Page
Loading...