ChipSHOUTER Users Manual: Serial Interface
55
get fault_active g fa
Print any active faults, for example the current
state of the probe open detection.
get fault_latch g fl
Print any latched faults, which may not be cur-
rently active but occurred once and must be
cleared manually.
get fault [latched / current] <type> g f [l / c] <t>
Get the state of a specific fault, current or
latched. <type> is the fault type, and <t> is the
associated shorthand. Table of <type> options be-
low.
Details on fault meanings
and troubleshooting can
be found in the faults
section of this manual.
To Next Page
Loading...