20
Installing the SDM-S (Not included)
The SDM-S does not support hot plugging. Therefore, you must insert or remove the SDM-S when the display is
powered off. Otherwise, the display or SDM-S may be damaged.
Currently we don't provide SDM-S, but if you have a SDM-S to use, please install refering to the following steps.
Unscrew the 2 screws on the SDM-S slot and remove the shielding cover.
Insert the SDM-S into the port on the rear of the panel until firmly seated, using the 2 screws to secure it.
Please install SDM-S first before you hang panel on the wall.
To Next Page
Loading...
Need help?
General
