To Next PageTo Next Page
Need help?Do you have a question about the Newmac NS220E and is the answer not in the manual?
Essential safety precautions for installation and operation, including warnings against specific actions.
Specifies approved chimney types, connection standards, and materials for safe venting.
Step-by-step guide for physically installing the heater unit, including placement and connections.
Minimum distances required for non-combustible floor protection materials around the heater.
Safety distances required from combustible walls and ceilings for the NS220E model.
Safety distances required from combustible walls and ceilings for the NC100E model.
Safety distances required from combustible walls and ceilings for the NCM120E model.
Methods and materials for safely reducing clearances using non-combustible wall protection.
Instructions on adjusting the thermostat and burn rate controls for optimal performance.
Important safety notes and warnings to prevent hazards during installation and use.
Specifications and requirements for the stovepipe connector, including material and sealing.
Procedures for safely connecting the heater to a masonry chimney.
Guidelines for connecting the heater to a masonry fireplace, including flue area.
How to connect the heater to listed factory-built chimney systems.
Basic rules for effective and safe chimney operation, including termination heights.
Importance and methods for supplying outside combustion air to ensure proper operation.
Specifics on routing external air to the heater, including duct size and termination.
Guidance on appropriate wood fuel types and safe methods for loading the heater.
Overview of primary and secondary air inlets and their functions for efficient burning.
Detailed instructions for operating the Secondary Air Timer for optimal burn and efficiency.
Visual cues from the chimney indicating correct heater operation and heat loss.
Step-by-step guide to safely and effectively start the heater.
Best practices for adding fuel to a burning heater to maintain draft and prevent back-puffing.
Addresses common problems like smoke, high fuel use, back-draft, and back-puff.
Recommended methods for safely handling, storing, and disposing of ashes.
Instructions for assembling the NS220E unit, including base and firebox attachment.
Specific requirements for installing the heater in a mobile home, including anchoring.
Guidance on structural framing dimensions and ceiling support box installation.
Placement and dimensions for the outside air intake duct and floor protector.
Procedures for connecting the outside air duct to the heater and floor.
Regulations for chimney termination height above the roof and roof pitch considerations.
How to properly install roof flashing for a watertight seal around the chimney.
Instructions for disconnecting and removing the chimney for mobile home transport.
Explains why creosote forms and how to minimize its buildup for safety.
Advice on inspection frequency and measures to prevent chimney fires.
Actions to take if a chimney fire is suspected, including reducing air and securing doors.
How to maintain the exterior enamel finish and adjust the loading door seal.
Instructions for fitting and using the optional circulating fan for improved air distribution.
Information on identifying and ordering replacement components using part numbers.
Steps required to initiate and process a warranty claim, including required documentation.
Comprehensive list of part numbers and descriptions for the NS220E model.
Visual guide showing the location of components for the NS220E model.
Comprehensive list of part numbers and descriptions for the NC100E model.
Visual guide showing the location of components for the NC100E model.
Comprehensive list of part numbers and descriptions for the NCM120E model.
Visual guide showing the location of components for the NCM120E model.
EPA performance metrics for smoke emission and efficiency for the Status EPA model.
EPA performance metrics for smoke emission and efficiency for the Classic I EPA model.
EPA performance metrics for smoke emission and efficiency for the Classic II EPA model.
Detailed explanation of warranty coverage, exclusions, and procedures for making a claim.
General| Fuel Type | Wood |
|---|---|
| Efficiency | 75% HHV |
| Weight | 450 lbs |
| EPA certified | Yes |
| Heating Area | 1, 200 - 2, 200 sq ft |
| Emissions | 2.5 g/hr |
| Heating capacity | 1, 200 - 2, 200 sq ft |
