Chapter 10 Specifications 101
Temperature Calibration
Thermistor 1/T = (C1 x 10
-3
) + (C2 x 10
-4
)(ln R) + (C3 x 10
-7
)(ln R)
3
AD590 T = C1 + C2 x (I
AD590
/1µA/K - 273.15)
LM335 T = C1 + C2 x (V
LM335
/10mV/K - 273.15)
Pt RTD Rt = Ro [ 1 + C1t + C2t
2
] ; t
≥
0 °C,
Rt = Ro [ 1 + C1t + C2t
2
+ C3t
3
(t - 100)] ; t < 0 °C
Ro = resistance at 0 °C where, Ro=100
Ω
for a 100
Ω
Pt RTD.
10.4 Mainframe And General Specifications
Display
Type LCD character display, 4 lines by 20 characters
Back Lighting Green LED
Controls Brightness and Contrast (contrast optimizes viewing angle)
Channel Active For Model 6000, Green LDD LED indicates that Laser Diode output is on. Green
TEC ACTIVE LED indicates that TEC output is on. For Model 6000M and
6000MF, Green OSC LED and AMP LED indicate the oscillator and amplifier are
on, respectively. The on state of the TEC is indicated on the master display. The
LCD display shows details of active channels.
Output Connectors
Temperature Controller (TEC) 15-pin female D-sub
Laser Diode Driver (LDD) 9-pin female D-sub, BNC (external modulation), BNC (auxiliary photodiode input)
MOPA (6000M and 6000MF only) 15-pin female D-sub, BNC (external modulation)
Chassis Ground 4 mm Banana Jack
GPIB Connector 24 pin IEEE-488
RS232 Connector 9-pin male D-sub
Power Requirements 90 to 132 volts, 2.25 Amp Max.; 198 to 250 volts, 1 Amp Max. (user selectable),
50 to 60 Hz
Size (H x W x D) 86 mm x 356 mm x 356 mm (3.5 " x 14" x 14")
Mainframe Weight 9.5 kg (21 lbs.)
Modules Weight 1.1 kg (2.5 lbs.), typical weight each
Operating Temperature 0 to 40°C, < 70% relative humidity non-condensing
Storage Temperature -20°C to 60°C, < 90% relative humidity non-condensing
Laser Safety Features Laser Enable Key switch, Interlock, Output Delay (meets CDRH US21 CFR
1040.10). Interlock and output delay are part of the Laser Module.
Isolation TEC and Laser sections electrically isolated with respect to each other and from
earth ground.
In accordance with ongoing efforts to continuously improve our products, Newport
Corporation reserves the right to modify product specifications without notice and
without liability for such changes.
To Previous Page
Loading...
