Newport 6000 - System Configure Screen; Figure 8 - System Configure Screen

Chapter 2 System Operation 17
2.4.8 System Configure Screen
→
→→
→
Contrast= 11 %



Brightness= 100 %



Lockout dial= No



Lockout pad= No
→
→→
→
Audible beep= Yes






On Delay= 3.0 S



Key Rate= Fast



Dial Rate= Fast
Figure 8 – System Configure Screen
The system configure screen controls basic operation of the 6000 system.
Brightness
varies the backlighting intensity.
Contrast
is used to optimize the viewing angle.
Lockout dial
disables the dial to avoid accidental changes in active data fields when
the dial is bumped.
Lockout pad
locks out the left and right arrow keys, the data entry portion on the
keypad. Navigation keys, such as up and down,
MENU
,
MASTER
, and
FUNC
continue to work.
Note that both the Lockout dial and Lockout pad settings are temporarily suspended
while in the Configure System Screen, allowing the dial and keypad lockout settings
to be changed while in this screen..
Audible Beep
controls the system’s audible beeper. The beeper indicates errors,
invalid data entry, and other situations where the 6000 needs to alert the user. Each
press of the
MASTER
button will clear one error.
On Delay
controls the delay time from the moment a Laser Diode Driver is turned on
by the user to the actual time the output is energized. The delay time is
programmable from 0 seconds to 30 seconds. The default setting is 3 seconds.
Key Rate
- this controls the speed at which, when a key is held down, it repeats.
Settings are
Slow
,
Medium
, and
Fast
.