Newport 6000 - Configure Menu; Figure 6 - Main Menu; Figure 7 - Configure Menu

16 Chapter 2 System Operation
1.
MODULES
- Pressing the adjacent soft key gives access
to the laser module and TEC for setup and control of each
module.
2.
COMM
- Pressing the adjacent soft key gives access to
the GPIB and RS232 parameters.
3.
LOCAL
- When the unit is in remote mode, either
through GPIB or RS-232C communications, the
Local
soft key will be available. Pressing it returns the 6000 to a
local state. When in local mode, this key does not appear
on the display. The 6000 is placed in remote mode
through GPIB or RS232 communication, or during the
execution of a macro or special function.
4.
CONFIG
- Pressing the adjacent soft key gives access to
the general configuration menu, with soft keys to access
system configure, save/recall, linking, and calibration
screens.
Main Menu MODULES
←
←←
←
COMM
LOCAL
CONFIG
←
←←
←
Figure 6 - Main Menu
2.4.7 Configure Menu
The configure menu provides access to the system configuration, save and recall, and
linking screens.
Config SYSTEM
←
←←
←
LINKING
CAL
SAV/RCL
←
←←
←
Figure 7 - Configure Menu