Chapter 2 System Operation 15
2.4.4 Master Display
The Master Display is shown in Figure 4. This is the highest level display and
indicates the general status of both the laser module and TEC in the system at the
same time.
LDD
→
→→
→
Io= 450.00 mA
Po= 0.00 mW
TEC
Ts= 25.00 °C
T = 23.50 °C
Figure 4 - Master Display
The Master Display can be accessed from any screen in the system by pressing
MASTER
. If there is no laser module detected in the system, the text “Not installed”
will appear in place of the laser module’s status information.
2.4.5 MOPA Master Display
OSC
→
→→
→
Io= 1.66 mA
AMP Im= 0.0 µA
Io= 741.6 mA
TEC T = 25.00 °C OFF
Figure 5 - MOPA Master Display
The MOPA Master Display is used on Model 6000M and 6000MF controllers. The
Master Display can be accessed from any screen in the system by pressing
MASTER
. The lower soft key controls the TEC on/off state. The soft key indicates
the current state of the TEC output.
2.4.6 Main Menu
The Main Menu is shown in Figure 6. This is the second highest menu and is used to
access four general system functions:
TEC On/Off soft
key
To Next Page
Loading...
