Chapter 1 General Information 5
WARNING
The American National Safety Institute (ANSI) states that
a shock hazard exists when probes or sensors are exposed
to voltage levels greater then 42 VDC or 42V peak AC.
Do not exceed 42V between any portion of the Model
8000 (or any attached detector or probe) and earth ground
or a shock hazard will result.
CAUTION
There are no serviceable parts inside the Model 8000.
Work performed by persons not authorized by Newport
Corporation may void the warranty. For instructions on
obtaining warranty repair or service please refer to
Chapter 8 of this manual.
To Next Page
Loading...
