Newport 6000 - 2.3 Front Panel Operation; 3.3 TEC Module Theory

v
7.1 Calibration Overview_______________________________________________ 73
7.1.1 Environmental Conditions _______________________________________________ 73
7.1.2 Warm-Up ____________________________________________________________ 73
7.2 Laser Calibration __________________________________________________ 73
7.2.1 Recommended Equipment _______________________________________________ 73
7.2.2 Drive Current Load Resistor Selection______________________________________ 74
7.2.3 Local Operation Current Source Calibration _________________________________ 74
7.2.4 Remote Operation Current Source Calibration________________________________ 75
7.2.5 Local Operation I
PD
Current Calibration_____________________________________ 76
7.2.6 Remote Operation I
PD
Current Calibration ___________________________________ 77
7.2.7 Local Operation Laser Voltage Measurement Calibration _______________________ 78
7.2.8 Remote Operation Laser Voltage Measurement Calibration _____________________ 79
7.3 TEC Calibration ___________________________________________________ 80
7.3.1 Recommended Equipment _______________________________________________ 80
7.3.2 Local Operation Thermistor Calibration_____________________________________ 80
7.3.3 Remote Operation Thermistor Calibration ___________________________________ 81
7.3.4 Local Operation AD590 Sensor Calibration__________________________________ 82
7.3.5 Remote Operation AD590 Sensor Calibration ________________________________ 82
7.3.6 Local Operation LM335 Sensor Calibration__________________________________ 83
7.3.7 Remote Operation LM335 Sensor Calibration ________________________________ 83
7.3.8 Local Operation RTD Calibration _________________________________________ 84
7.3.9 Remote Operation RTD Calibration________________________________________ 84
7.3.10 RTD Lead Resistance Calibration (Offset Null)_______________________________ 85
7.3.11 Local Operation I
TE
Current Calibration ____________________________________ 85
7.3.12 Remote Operation I
TE
Current Calibration, Single Channel TEC _________________ 86
8. Factory Service________________________________________________89
8.1 Introduction_______________________________________________________ 89
8.2 Obtaining Service __________________________________________________ 89
9. Error Messages _______________________________________________93
9.1 Introduction_______________________________________________________ 93
10. Specifications _________________________________________________97
10.1 Laser Diode Driver (LDD) Modules _________________________________ 97
10.2 MOPA Laser Diode Driver Module _________________________________ 98
10.3 Temperature Controller (TEC) Specifications________________________ 100
10.4 Mainframe And General Specifications _____________________________ 101
Tables
Table 1 - Laser Connector Pinouts___________________________________________________ 41
Table 2 - MOPA Laser Connector Pinouts_____________________________________________ 41